Xerox Phaser 5335 User Manual

6.6 Error Messages and Error Codes 131
Open Tray 2 & 3
Clear Jam
 
then
Open & Close A
A paper jam occurred in the printer.
Pull out Tray 2 and Tray 3 to identify the jammed area, and clear the jammed paper.
Then, open and close the front cover. Open the front cover even when there is no
jammed paper inside the cover. The error will not clear unless you open and close
the front cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 113)
Open Tray 4, 3
& 2. Clear Jam
 
then
Open & Close A
A paper jam occurred in the printer.
Pull out Tray 2, Tray 3, and Tray 4 to identify the jammed area, and clear the jammed
paper. Then, open and close the front cover. Open the front cover even when there is
no jammed paper inside the cover. The error will not clear unless you open and close
the front cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 113)
Out of memory
 
Press SET
and Cancel JOB
The job cannot be printed due to insufficient memory.
Cancel the job by pressing the
<OK/Eject> button on the control panel.
Reduce the number of files to print and try printing again. If the same message keeps
appearing, we suggest you to install additional memory.
PDL Error
 
Press SET
and Cancel JOB
An error occurred while processing the job.
Cancel the job by pressing the
<OK/Eject> button on the control panel.
Check if there is any problem with the print data.
Push in
all trays
The job requested a paper tray, but one of the trays above it is open.
Close the open tray.
Push in Tray N
(N: tray 2 - 5)
The tray N is open.
Push the tray firmly into the printer.
Push in trays One of the trays is open when printing.
Push the tray firmly into the printer.
Ready to print
Maintenance Kit
 
Ready to print
Replace soon
The maintenance kit (regular replacement part) needs to be replaced soon. Have a
new maintenance kit ready.
Ready to print
Toner Cartridge
 
Ready to print
Replace soon
The print cartridge needs to be replaced soon. Have a new cartridge ready.
Reboot printer
(***-***)
There is a printer fault.
Switch the power off, wait for the display to go out, and switch the power back on
again. If the same error code is displayed, copy down the error code (***-***), and
Contact your Customer Support Center or your dealer.
Refer to
• "Error Codes" (P. 133)
Replace
Toner Cartridge
The print cartridge has run out of toner.
Replace the print cartridge.
Refer to
• "Replacing the Print Cartridge" (P. 141)
• "Type of Consumable" (P. 139)
Set Tray N
xx xx xxxx
(N: tray 2- 5)
The size of the paper loaded in the tray N does not match the paper size requested
by the job.
Load the paper indicated in the message (xx xx xxxx) in the tray N.
Refer to
• "Loading Paper in Trays 2 - 5" (P. 64)
Message Symptom/Cause/Remedy

Xerox Phaser 5335 Specifications

General

Brand	Xerox
Model	Phaser 5335
Category	Printer
Language	English