Xerox Phaser 5335 - Page 52

34 3 Print
Note
• When loading the envelopes in the tray, make sure
that the flaps are completely open.
• When setting the margins on your application, add
one-half length of the flap (from the top edge to the
fold line) to the margin on the flap side.
Loading Envelopes in Tray 2 - 4
 Envelopes with Adhesive Flaps
1. Load the envelopes with the address side
facing up and the edge with the flaps on
your right. Make sure that the flaps are
closed.
2. Adjust the paper guides to the size of the
envelopes.
3. Set the paper size dial to [
*
].
 Envelopes with Non-adhesive Flaps
1. Load the envelope with the address side
facing up and the edge with the flaps on
your left. Make sure that the flaps are open.
2. Adjust the paper guides to the size of the
envelopes.
Note
• When loading the envelopes in the tray, make sure
that the flaps are completely open.
• When setting the margins on your application, add
one-half length of the flap (from the top edge to the
fold line) to the margin on the flap side.
3. Set the paper size dial to [
*
].