5. At the control panel, select the correct paper size, type, and color. Ensure that the paper type is set to Labels.
Note: To change the paper settings when the tray is set to Dedicated mode, refer to Configuring Tray
Settings.
6. To confirm the settings, touch OOKK.
7. To return to the Home screen, press the HHoommee button.
Loading Labels in Tray 6
1. Pull out Tray 6 from the high-capacity feeder until it stops. Open the side gate until it stops.
2. Wait for the tray to lower and stop.
Note: Ensure that labels are the correct size for the tray. Do not load custom-size paper into Tray 6.
3. To load labels in the tray, insert labels face up with the top edge toward the back. Stack the labels against the
right side of the tray as shown.
Note: Do not load paper above the maximum fill line. Overfilling can cause paper jams.
4. Close the tray door.
5. At the control panel, select the correct paper type and color. Ensure that the paper type is set to Labels.
Note: To change the paper settings when the tray is set to Dedicated mode, refer to Configuring Tray
Settings.
6. To confirm the settings, touch OOKK.
Xerox
®
VersaLink
®
C71XX Series Color Multifunction Printer User Guide 191
Paper and Media
To Next Page
Loading...
