Xerox Customized Envelope Feeder – Problem Solving Guide 2-9
E Power Problems
Is the Feeder powered on?
Y N
Move the Feeder Power Switch to the ON position.
The Feeder Power Switch is located on the inboard side of the Feeder.
Is the Feeder Mode Switch set to READY?
The Feeder Mode Switch is located on the outboard side of the Feeder.
Y N
Move the Feeder Mode Switch to the READY position.
Press the RESET Button (the RESET Button is only present on XPF125Axxx and XPFB125xxx models).
Does the problem still exist?
Y N
Problem resolved.
Check and secure the power cord at the AC power outlet (power source) and at the AC power inlet on
the rear of the Feeder. Replace the power cord if it is damaged.
To Next Page
Loading...
Need help?
General