Xerox Versant 80 Press - Page 7

Versant 80 Press
Customer Expectation & Installation Guide 3
Finishing Options
IMPORTANT: Refer to Configuration Dependencies for information on configuration requirements for the finishing devices.
High Capacity Stacker (HCS) The HCS is designed for long production runs:
 Top tray has a maximum 500 sheet capacity
 Stacking a maximum of 5,000 sheets (based on 80 gsm centerline paper) and offsetting the
output in the stack tray/cart
 The movable stack tray/cart provides easy transition of the output to off-line finishing
 An additional stack tray/cart is available for the customer to order
 Sample prints are additional prints that are directed to the top tray for inspection. Sample
prints are not produced by redirecting sheets from the stack tray/cart to the top tray;
therefore the contents in the stack tray/cart are complete
Standard Finisher The Standard Finisher features include a basic in- line punch, stapler, the stacker tray, and top
exit tray. It also includes a built-in interposer (inserter) and a built-in decurler unit that corrects
the curl on paper output from the print engine. An optional C/Z Folder is available which
includes the C-Fold, Z-Fold, and Z-Fold Half Sheet. Refer to C/Z Folder for more information.
Booklet Maker Finisher The Booklet Maker Finisher features include a basic in-line punch, stapler, the stacker tray, top
exit tray, and a booklet unit capable of saddle stapling and bi-fold. It also includes a built-in
decurler unit that corrects the curl on paper output from the print engine and a built-in
interposer (inserter) that feeds cover paper to the finisher for saddle-staple operation. An
optional C/Z Folder is available which includes the C-Fold, Z-Fold, and Z-Fold Half Sheet. Refer to
C/Z Folder for more information.
Standard Finisher Plus The Standard Finisher Plus includes the functionality of the Standard Finisher and adds
interface/trans- port module to enable connection to third party finishing solutions. An optional
C/Z Folder is available which includes the C-Fold, Z-Fold, and Z-Fold Half Sheet. Refer to C/Z
Folder for more information.
C/Z Folder This optional unit can perform C-Fold, Z-fold, and Z- Fold Half-Sheet (also called Engineering Z-
Fold). The C/Z Folder can be added to these finishing devices:
 Standard Finisher
 Booklet Maker Finisher
 Standard Finisher Plus
SquareFold
®
Trimmer Module This optional device is available only with the Booklet Maker Finisher (with or without the C/Z
Folder). The SquareFold Trimmer Module flattens the spine of the booklet and trims the face of
the booklet.
2-Knife Timmer This optional device is available only with the SquareFold Trimmer module. Provides full-bleed
trim up to 3/16” (5mm) thickness, adjustable trim dimensions, no DFA required.
Other Options
Foreign Interface Kit The Foreign Interface Kit enables the connection of external devices such as auditrons or coin-
op devices. This will perform in copy and print modes.
Convenience Stapler Staple up to 50 sheets of 90 gsm/24 lb media.
Common Access Card Enablement Kit Security feature to identify user based on two-factor identification requirement
–
access card
plus user PIN.
Network Accounting Kit Enables reporting and user/device management in combination with optional accounting
solutions.
USB Enablement Kit Enables scan-to-USB functionality.
Configuration Dependencies
The following dependencies are required for all or certain configurations:
Performance Package Not compatible with:
 BR Finisher
 OCT