7. Wipe the Pinch Rollers with a dry cloth.
8. With both hands grasp each side of the lid and pull it toward you, allowing it to close
gently under its own weight. Ensure that each side clicks into the locked position by
pressing firmly on both the left and right ends.
9. Wipe the outside of the Scanner with a damp cloth. If the dirt does not come off
easily, try gently wiping it with a moistened soft cloth with a small amount of neutral
detergent.
NOTE
Do not use cleaning agents other than water, a neutral detergent, Isopropanol,
and Xerox Platen Glass Lens and Mirror Cleaner.
10. Replace the top Power Cord to restore power to the Scanner.
11. Press the On/Off Switch behind the Scanner to turn it to the On (up) position.
NOTE
Ensure the areas are fully dry before scanning.
To Clean the User Interface (UI)
The User Interface Touch Screen becomes soiled with fingerprints and needs to be
cleaned on a regular basis. Apply Xerox Platen Glass Lens and Mirror Cleaner or Xerox
Film Remover with a clean cloth.
7-11
Xerox
®
Wide Format 6604/6605 Solution
™
User Guide
Maintenance
To Next Page
Loading...
