Xerox WorkCentre 3045

Troubleshooting
176 WorkCentre 3045 Multifunction Printer
User Guide
Symptom Solutions
The output is blank. • Turn off the printer, then turn it on again.
• If the error persists, contact your Xerox representative.
Streaks appear in the output. Contact your Xerox representative.
The output has a mottled
appearance.
• Verify that the paper is the correct size, type, and weight. If not, change
the paper settings.
• Adjust the bias transfer roller. For details, see Adjusting the Bias Transfer
Roller on page 148.
Ghosting appears in the printed
output.
• Verify that the paper is the correct size, type, and weight. If not, change
the paper settings.
• Change the Paper Type settings in the print driver.
In the Printing Preferences of the print driver, on the Paper/Output tab,
change the Paper Type setting.
• Adjust the bias transfer roller. For details, see Adjusting the Bias Transfer
Roller on page 148.
• Adjust the fuser. For details, see Adjusting the Fusing Unit on page 148.