6 UNIX TCP/IP
92 Xerox WorkCentre 7232/7242 System Administration Guide
Specifying double-sided printing
The following parameters can be specified.
NOTE: If several parameters are specified in an lpr command, data may not print
correctly.
NOTE: The system default is used if no parameter is specified.
NOTE: If the print data specifies double-sided or single-sided printing, those
specifications take priority over any -C option.
Specifying paper size and double-sided printing
Select a paper size and a binding option. The following parameters can be specified:
Parameter Description
PTS/pts Selects plain paper.
PT1/pt1 Selects thick paper 1.
POH/poh Selects transparency.
PTP/ptp Selects tracing paper.
PRC/prc Selects recycled paper.
Parameter Description
DUP/dup Double-sided printing as follows:
TUMBLE/tumble Double-sided printing as follows:
SIMP/simp Single-sided printing
Parameter Description
A3D/a3d Double-sided printing on A3 (297 × 420 mm/11.7 × 16.5
inches) paper and long-edge binding
A3T/a3t Double-sided printing on A3 (297 × 420 mm/11.7 × 16.5
inches) paper and short-edge binding
A4D/a4d Double-sided printing on A4 (210 × 297 mm/8.3 × 11.7
inches) paper and long-edge binding
A4T/a4t Double-sided printing on A4 (210 × 297 mm/8.3 × 11.7
inches) paper and short-edge binding
A B
C D
A B
C D
To Next Page
Loading...
Need help?
General
