Installation
4 DocuMate 152 Scanner User’s Guide
Installation
Installation is a quick, four-step process:
1. Assemble the scanner
2. Install the software
3. Connect the power supply
4. Connect the USB cable and turn on the power
Before You Begin
Please make sure of the following before you begin installation:
• The information in this guide may cover software not
provided with the scanner you purchased. Disregard any
information about the software not applicable to your
chosen product. Please visit our web site at
www.xeroxscanners.com for the latest software updates
for your Xerox DocuMate 152 scanner.
• If your computer has AntiVirus or AntiSpyware software
running, you may see messages during installation asking
you to allow the installation to proceed. Although the
messages will differ based on the software your computer
is running, in each case you should allow the installation
to proceed. Alternatively, you can turn off the AntiVirus or
AntiSpyware software before installing your scanner, but if
you do, make sure to turn it back on again when
installation is finished.
• If you already have a scanner connected to your computer,
you need to remove its driver programs first before
beginning the installation of your Xerox DocuMate 152
scanner. Please see “Uninstalling Your Scanner” on
page 110 for basic instructions, or see the User’s Guide
that you received with your other scanner for specific
instructions.
To Next Page
Loading...
Need help?
General