Scanning from PaperPort
86 DocuMate 152 Scanner User’s Guide
5. When scanning documents, use the Create single page items
check box as follows:
• When the check box is selected, all pages in the Automatic
Document Feeder are scanned, the TWAIN interface
closes, and each page is placed on the PaperPort Desktop
as an individual file.
• When the check box is not selected, the scanned pages are
not placed on the PaperPort Desktop until you indicate the
scanning job is finished by clicking Done on the TWAIN
interface then clicking Done on the PaperPort-Scan
window. Multiple pages are “stacked” on the PaperPort
Desktop. Please see the ScanSoft PaperPort User’s Guide
for more information about stacks.
6. The option Blank page is job separator is for when you load
several separate scanning jobs into the Automatic Document
Feeder at the same time. Insert a blank page between them
and each job will become a separate stack on the PaperPort
Desktop when scanning is finished.
Please see the ScanSoft PaperPort User’s Guide for more
information about this option.
7. Select the option, Display scanner dialog box.
When this option is selected, the PaperPort TWAIN interface
will open when you click the Scan button (at the bottom of the
Scan pane) so you can select new scan settings.
If the option is not selected, you can scan directly from
PaperPort without displaying the TWAIN interface first. Just
insert a page into the scanner and click the Scan button. By
default, the scanner scans the face-down side of the page only
(a Simplex scan), using the scanner’s current settings. To
change the default so the scanner scans both sides of the
page, or to select other settings for scanning directly from
PaperPort, see the ScanSoft PaperPort User’s Guide.
8. Click the Scan button on the Scan pane.
To Next Page
Loading...
