25
Input the desired frequency values number by number and then press [F-INP
ENT] again to complete setting the frequency.
For example, press the keys in the
following sequence to set current
frequency to 14.09000MHz:
1. Press [F-INP ENT] key first;
2. Press the number keys 1 by 1;
3. Press [F-INP ENT] button again to complete the action.
3. Quick adjustment of the frequency with the multi-function knob
The Multi-function Adjustment Knob of the G90/S provides a method to quickly
tune across the band. The function knob’s default function and increment is
100khz. Hop from the CW to the SSB areas of the band in seconds.
Note: This only works if the multi-function knob is set to change frequency. If its
function has been changed (e.g. to SQL level) you will not be able to tune using
the multi-function knob.
Adjustment of RF Gain and Muting Level
Proper RF gain adjustment can improve the quality of a received signal. In
general, reducing the RF gain level on the low bands (40/60/80/160m) which
have strong interference can significantly improve receive quality. In general,
with SDR rigs, operating at full RF gain is detrimental to receive signal quality.
Experiment with levels to find what is best for you.
How to adjust the RF gain:
1. Apply a long press on the [AGC] button at the bottom of the screen to enable
the setting of RFGAIN.
2. Rotate the main tuning knob to adjust the RF gain value.
3. After setting your RF gain level, press the main knob inwards momentarily to
exit the RF gain setting mode
SQL setting
You set the squelch level when you want to mute static in between
transmissions normally used on AM or FM modes but will work on all phone
modes.
To Next Page
Loading...
