XIEGU G90S - Reception and Transmission Operations Using SPL and VFOA;B

27
Once in the user defined functions menu turn either the multi-function knob or
the main tuning dial to go to one of the following functions:
1 Freq 100k Frequency stepping value
2 SQL level Muting level setting
3 PO Level Transmitter output power
4 Key Speed Automatic keyer rate
5 FFT Scale Spectrum reference level
When you are on the function you want to adjust e.g. squelch, momentarily
press the multi-function knob in again. This will take you back to the normal
operating screen. As soon as the receive screen is displayed rotate the multi-
function knob and where the bandwidth icon is normally displayed on the
screen, the available values for the selected function available will be displayed
as you turn the knob. When you have the value displayed that you wish to have,
momentarily press the multi-function knob again to keep the value.
Note: If you wait too long you will be put into DSP filter adjustment mode. If this
happens, start again.
Reception and Transmission Operations using SPL and
VFOA/B
The G90/S transceiver has two built-in, independent, VFOs which can be set to
different frequencies and different modes. Using the SPL (split) function, you
can transmit and receive on different frequencies or even bands.
VFO operation
Split Frequency
Operation