37
Channel Memory Write (MW) and Clear (MC)
Basic operations:
1. While in VFO mode, set the required frequency, mode, and any other
parameters you desire.
2. Press the [MW/MC] button momentarily and the CH 00 (channel number)
character will appear on the screen flashing. Rotate the main tuning knob to
select an empty channel. At this time, the character E will appear after the
channel number, indicating that the channel is empty and can be used for
storage.
3. Press the [MW/MC] button again momentarily to save the current frequency
and mode information to the selected channel.
Selecting the stored memory channels:
1. In VFO mode, press the [VM] button momentarily to enter channel mode.
2. Rotate the main tuning knob to switch to the required channel.
Clear channel memory:
1. In channel mode, press the [FUNC] button followed by the [MW/MC] button.
The channel number indicator will start to flash in red.
2. Rotate the main tuning knob to the channel to be wiped. Press the [MW/MC]
button again to clear the selected channel.
Transmitter Power Setting
1. Press the [POW] button momentarily to enter the power setting mode. The
display area on the right side of the screen will display the current “Po” power
output setting value in watts.
2. Rotate the main tuning knob to set the power to the desired value in steps
from 1W to 20W.
POW button
To Next Page
Loading...
