52
Firmware upgrades
Xiegu regularly releases firmware updates for the G90/S. Please go to
radioddity.com and follow the Support link. All information for updating your
G90/S will be there. The USB cable for performing updates is included with the
G90/S or you can perform the upgrade via the (optional) DE-19 unit. Be sure to
install the appropriate driver from the Radioddity website on your PC before
inserting the USB cable into your PC.
WARNING! When using the simple USB-Serial lead for connectivity
between PC and radio, turning the radio on with the cable plugged into
either the 3.5mm COMM sockets (in the head or main unit), can cause
the radio to think you wish to update the firmware and you will have a
radio that is non-operative and will have to perform a firmware update
before you can use the radio again!! This problem does not occur when
using the DE-19.
Here is a list of the most recent improvements in the radio’s firmware:
What’s new in v1.8 (12
th
May 2023)
UPDATE DISP UNIT ONLY!!
1. To work with JTDX/WSJTX (or some other data mode software), added CI-V
commands 0x25,0x26.
2. Add CI-V command 0x1d 0x19, read the XIEGU RADIO ID.
What’s new in v1.79b03 (26
th
October 2022)
Changes:
1. Fix AM/NFM filter issue
2. New colour map for waterfall
What’s new in v1.79b02 (14
th
October 2022)
1. Improved the AGC algorithm.
2. Improved the Filter's algorithms.
Additional functions/improvements:
1. New data mode: U-D; L-D, for USB DIG; LSB DIG，
In data mode: ACC port LINE IN is selected as audio in and the hand
mic is muted; LINE OUT via the ACC socket is enabled
2. The band-pass filter is changed to allow 2 BPF defaults that can be
switched between. The default values of each filter by mode are:
To Next Page
Loading...
