Xilinx Virtex-7 FPGA VC7222 IBERT - GTH IBERT Demonstration Procedure

8 www.xilinx.com VC7222 IBERT Getting Started Guide
UG971 (v5.0) June 12, 2014
Chapter 1: VC7222 IBERT Getting Started Guide
Running the GTH IBERT Demonstration
The GTH IBERT demonstration operates one GTH Quad at a time. This section describes
how to test GTH Quad 115, while the remaining GTH Quads are tested following similar
steps.
Connecting the GTH Transceivers and Reference Clocks
Figure 1-1 shows the locations for all the GTH transceiver Quads on the Rev. B VC7222
board.
Note:
Figure 1-1 is for reference only and might not reflect the current revision of the board.
X-Ref Target - Figure 1-1
Figure 1-1: GTH Quad Location
8*BFBB
48$'B
48$'B
48$'B
48$'B
48$'B
48$'B
Send Feedback