ZCU111 Board User Guide 9
UG1271 (v1.1) August 6, 2018 www.xilinx.com
Chapter 1: Introduction
°
PS MIO[32:37]: PMU_GPIO[0:5]
°
PS MIO[38]: PS_GPIO1
°
PS MIO[44:51]: SD I/F
°
PS MIO[52:63]: USB3.0
°
PS MIO[64:77]: GEM3 Ethernet
• PL I/O connections:
°
PL-side user DIP switch (8-position)
°
PL-side CPU reset pushbutton
°
PL-side user LEDs (eight)
°
PL-side user pushbuttons (five, geographic N, S, E, W, C)
°
PL-side PMOD0/1 (two R.A. 2x6 receptacles)
• Security - PSBATT button battery backup
•SYSMON header
• Operational switches (power on/off, PROG_B, boot mode DIP switch)
• Operational status LEDs (INIT, DONE, PS STATUS, PGOOD)
• Power management
• System controller (MSP430)
The ZCU111 provides a rapid prototyping platform using the XCZU28DR-2EFFVG1517
device. See the Zynq UltraScale+ RFSoC Data Sheet: Overview (DS889) [Ref 1] for a feature
set overview, description, and ordering information.
Board Specifications
Dimensions
Height: 11.811 inches (30.0 cm)
Width: 7.874 inches (20.0 cm)
Thickness: 100.8 mil (0.2743 cm)
Note:
A 3D model of this board is not available.
See ZCU111 board documentation for the XDC listing and board schematics.
To Next Page
Loading...
