Xsensor ForeSite SS - Electromagnetic Emissions

Introducon6
Guidanceandmanufacturer’sdeclaraon–
electromagnecemissions
The ForeSite SS system is intended for use in the electromagnec
environments specied below. ForeSite SS system users should ensure
that it is used in such an environment.
Emissions Test Compliance Electromagnec
Environment Guidance
RF emissions CISPR 11 Group 1 The ForeSite SS system
uses RF energy only for
its internal funcon.
Therefore, its RF
emissions are very low
and are not likely to
cause any interference
in the nearby electronic
equipment.
RF emissions CISPR 11 Class A The ForeSite SS system
is suitable for use in all
establishments other
than domesc and those
directly connected to the
public lowvoltage power
supply network that
supplies buildings used
for domesc purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage uctuaons/
icker emissions
IEC 61000-3-3
Complies
Recommendedseparaondistancesbetween
portableandmobileRFcommunicaonsequipmentandtheForeSiteSS
The ForeSite SS is intended for use in an electromagnec environment in which
radiated RF disturbances are controlled. The customer or the user of the ForeSite SS
can help prevent electromagnec interference by maintaining a minimum distance
between portable and mobile RF communicaons equipment (transmiers) and the
ForeSite SS as recommended below, according to the maximum output power of the
communicaons equipment.
Rated maximum
output power
of transmier
W
Separaon distance according to frequency of transmier
M
150 kHz to 80 MHz 80 MHz to 800 MHz 800 MHz to 2.5 GHz
0.01 0.12 0.12 0.24
0.1 0.37 0.37 0.74
1 1.17 1.17 2.34
10 3.69 3.69 7.38