9. Disconnect and remove any sensors, monitoring equipment, or oiler components if
applicable.
NOTE: Proceed to step 10 if the pump is currently disconnected from piping and
removed from its operating location. Otherwise, continue to step 10 after removing
the rotating assembly (with bearing housings) from the lower casing.
1. Remove the rotating assembly by first unfastening the four bolts which secure each
bearing housing to the lower casing.
2. Once the bearing housings are no longer fixed to the lower casing, lift and remove
the rotating assembly using proper lifting equipment. Do not lift the rotating
assembly by the eyebolts located on each bearing housing. Place the rotating
assembly on v-blocks to continue the disassembly process.
6 Maintenance
52 e-XC INSTRUCTION MANUAL
To Next Page
Loading...
