NOTE: Chargers can be identified by the MFR MOD
number on the charger label. If the first two digits of
the MFR MOD number read 1Q or 2Q, the equipment
is a Gen IV Q-Series charger.
Table 2. Charger Identification
MODEL NUMBER PREFIX DESCRIPTION
1Q Gen IV 120V
2Q Gen IV 230V
1 Gen III 120V
2 Gen III 230V
There are also physical differences between Gen III
and Gen IV chargers. Gen III charger wire harness
connections are on the right side of the charger face
only. Gen IV charger wire harness connections are on
both sides of the charger face. See Figure 17 and
Figure 18.
Figure 17. Gen III Charger
Figure 18. Gen IV Charger
For the Gen IV chargers, refer to Accusense® Gen IV
Charger 2200YRM2030 . For other charger models,
use this manual.
1. USB PORT (FACTORY USE ONLY)
2. MODE PORT DIP SWITCHES
Figure 19. Mode Port
ACCUSENSE Battery Charger 2200 YRM 1508
20
To Next Page
Loading...