Yale 524150797

BDI Display
REMOVE
NOTE: Access electrical connector and nuts through
u-shaped cutout in top of control panel.
1. Disconnect electrical connector from back of BDI
display. See Figure 23.
NOTE: Due to limited access, it is recommended that
a box end wrench is used to perform this repair.
2. Remove two nuts from back of BDI display. See
Figure 23.
3. Remove BDI display from front of control panel.
See Figure 23.
1. BDI DISPLAY
2. ELECTRICAL CONNECTOR
3. NUT
4. CONTROL PANEL
5. CONTROL PANEL CUTOUT
Figure 23. BDI Display
INSTALL
1. Install BDI display into front of control panel. See
Figure 23.
2. Install two nuts onto back of BDI display. See
Figure 23.
3. Install electrical connector into back of BDI
display. See Figure 23.
BDI Display 2200 YRM 1508
30