Yale SHAW-BOX

4 Installation
03.2018 39
ba-o.2.6.0-us-1.1-y | A11867501 Rev AA
Trolley types OE-S06 - OE-S07
Hook position
Eccentric position
X
Hook
position
Eccentric
[in]
1.5 - 1.59
1
A
1.61 - 1.79
C
1.81 - 1.99
2
A
2.01 - 2.19
C
2.2 - 2.38
3
A
2.4 - 2.58
C
2.6 - 2.78
4
A
2.8 - 2.97
C
2.99 - 3.17
5
A
3.19 - 3.37
C
3.39 - 3.56
6
A
3.58 - 3.76
C
Fig. 35
Fig. 36
Fig. 37
Fig. 38
1. Unscrew fixing elements (1) and (2).
2. OE-S07 4PD: The pieces of two units are supplied loose (please unscrew as
required).
3. Remove hook (3)
4. OE-S04: Rotate hook by 180°.
5. Insert adjusting screws “S” in the hook position determined from the table.
6. Position eccentric plates (4) in slot as specified by the table.
7. Tighten fixing elements (1) and (2) finger-tight.
Horizontal adjustment:
Fig. 39
Pos
OE-S04 -OE-S05
OE-S06 - OE-S07
[in]
[in]
Z
≥0.39
≥0.59
Y
≥1.18
≥1.18
1. Adjust final hook position according to Fig. and table.
2. Tighten fixing elements (1) and (2) with tightening torque M10 = 38 lb
f
ft.
NOTICE
Malfunction hazard. In the event of a fault, e.g. trolley running into the runway end
stops unchecked, broken rope, all elements of the anti-jump catch must be checked
immediately for damage/faults and completely replaced if necessary. The functional
reliability of the system must be ensured.