Yale SHAW-BOX

7 Inspection and maintenance
60 03.2018
ba-o.2.6.0-us-1.1-y | A11867501 Rev AA
7.1 Inspection intervals
Fig. 70
Test every day before starting work *1
Periodic inspection every 12
months *2
Inspection table
see page
●
●
Function of brakes (1) with regard to braking efficiency and activation
●
●
Emergency hoist limit switch (2), if there is no operational hoist limit switch, operational hoist limit
switch, if any
70
●
●
Emergency stop, travel limit switches, crane switch
42
●
●
Rope (4)
78
●
●
Check state of system for obvious defects
●
Check suspension of control pendant (cable and steel wire must be correctly
attached)
●
Load hook (5), cracks, distortion, wear, corrosion, function of hook safety latch
●
Overload safety device (6)
77
●
Disconnect switch and main isolator
42
●
PE connections and equipotential bonding
●
Establish remaining service life
86
●
Rope attachment (10) and rope sheaves
78, 83
●
Rope guide (11)
79, 81
●
Drive parts (12), wheel flanges, wheels etc.
85
●
Bolt joints, welds
●
End stops, buffers
●
Safety clearances
●
Power supply cable
●
Cable glands
●
Towing arm
●
Switching functions
●
All parts in the power flux
*1 By user
Periodic inspections including maintenance at least every 12 months, possibly more
frequently if so prescribed by national regulations, to be performed by a qualified person.
*2 Heavy duty or unfavorable conditions (dirt, solvents, multi-shift operation, etc.)
entail a reduction of this inspection and maintenance interval.
WARNING
Safety hazard. If work needs to be carried out on live parts, a second person must be
present who can stop dangerous movements in an emergency by means of the
emergency stop or disconnect the power supply by means of the main isolator /
disconnect switch.
W0789
12
5
4
12
1
1212
W0791