Remote Control Transmitter
608
C:::x:::x:::J
~
CJC:J-C::l
~
6c:::iC
a.::::x::5J
~~l§
DlQIo
PREPARATIONS
Batteries (size AA, UM-3, R6) (2)
RCA Pin Cable
II
Battery installation
II
Remote control transmitter opera-
tion range
Remote control sensor
II
Battery replacement
If
you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
.
:_1111:1;:1
• Use only AA, R6, UM-3 batteries for replacement.
• Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
• Remove the batteries if the remote control transmitter will not
be used for an extended period
of
time.
• If batteries leak, dispose
of
them immediately. Avoid
touching the leaked material
or
letting it come in contact with
clothing, etc. Clean the battery compartment thoroughly
before installing new batteries.
Within approximately
6 m (19.7 feet)
o
• There should be no large obstacles between the remote
control transmitter and the main unit.
• If the remote control sensor
is
directly illuminated by strong
lighting (especially an inverter type
of
fluorescent lamp, etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid direct
lighting.
E-3
Remote Control Transmitter
608
C:::x:::x:::J
~
CJC:J-C::l
~
6c:::iC
a.::::x::5J
~~l§
DlQIo
PREPARATIONS
Batteries (size AA, UM-3, R6) (2)
RCA Pin Cable
II
Battery installation
II
Remote control transmitter opera-
tion range
Remote control sensor
II
Battery replacement
If
you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
.
:_1111:1;:1
• Use only AA, R6, UM-3 batteries for replacement.
• Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
• Remove the batteries if the remote control transmitter will not
be used for an extended period
of
time.
• If batteries leak, dispose
of
them immediately. Avoid
touching the leaked material
or
letting it come in contact with
clothing, etc. Clean the battery compartment thoroughly
before installing new batteries.
Within approximately
6 m (19.7 feet)
o
• There should be no large obstacles between the remote
control transmitter and the main unit.
• If the remote control sensor
is
directly illuminated by strong
lighting (especially an inverter type
of
fluorescent lamp, etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid direct
lighting.
E-3
To Next Page
Loading...
