Yamaha CL1 - Page 31

CL Editor Owner’s Manual
31
A KEY IN SOURCE
Click this to select one of the following signals to use as the key-in source.
B CUE
This button cue-monitors the currently selected key-in signal. This is not shown in the Additional View.
If the Channel Select/Sends On Fader checkbox in the System Setup dialog box is not checked, the
[CUE] button will be hidden in the screen.
C KEY IN FILTER
Select the type of filter applied to the selected key-in signal; HPF (high pass filter), BPF (band pass filter), or LPF (low
pass filter.) The ON/OFF button switches the filter on/off.
If you’ve selected BPF, use the two knobs to adjust the band pass frequency and Q. If you’ve selected HPF or LPF, use
the knob to adjust the cutoff frequency.
If COMPRESSOR/EXPANDER is selected
1 TYPE
Indicates the currently selected compressor or expander. You can click here to select the type.
2 LIBRARY
This button accesses the dynamics library. Clicking this button will open the DYNAMICS page of the Library window.
3 ON
This button switches on/off for the compressor or the expander.
4 Response curve
Indicates the response for the compressor/expander of the currently selected channel.
5 GR meter (Gain Reduction meter)
This meter indicates the amount of gain reduction produced by the compressor/expander.
6 THRESH (Threshold level)
Specifies the threshold level at which the compressor/expander will operate. If the compressor is selected, the input sig-
nal will start being compressed when the key-in signal exceeds this level; compression will be removed when the signal
falls below this level. If the expander is selected, the input signal will start being compressed when the key-in signal falls
below this level; compression will be removed when the signal exceeds this level.
SELF PRE EQ The pre-EQ signal of the currently selected input channel
SELF POST EQ The post-EQ signal of the currently selected input channel
MIX OUT 21–24
The output signal of the corresponding MIX channel immediately before the output attenua-
tion
CH 1–72 POST EQ The post-EQ signal of the corresponding input channel (however, you can only choose chan-
nels belonging to the same group, within the eleven groups CH1–8, CH9–16, CH17–24,
CH25–32, CH33–40, CH41–48, CH49-56, CH57-64, CH65-72, and STIN1L–STIN4R,
STIN5L–STIN8R)
STIN1L–STIN8R POST EQ
NOTE
1
4
B
0
7
8
6
9
A
2 3
5