24
ADDITIONAL INFORMATION
Troubleshooting
If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the
simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the
power cord and contact your authorized YAMAHA dealer or service center for help.
The main unit does not switch ON
when STANDBY/ON is pressed.
No sound from one speaker.
The sound suddenly disappers.
No sound from an external
component connected with the main
unit or play does not begin.
Sound distorted.
Cannot set timer.
The main unit does not work
normally.
Excessive static in FM broadcasts.
Noise increases during stereo
broadcast reception.
Stereo broadcasts are noisy and the
STEREO indicator blinks on and off.
Cannot select preset stations.
Buzzing or static during AM
broadcasts.
AM broadcast sensitivity is poor.
SYMPTOM CAUSE REMEDY
Securely connect the power cord.
Connect properly.
Check the speaker wires are not touching each other
and then turn the main unit back on.
Connect the cords properly. If the problem persists,
the cords may be defective.
Select AUX by pressing the INPUT button.
Turn on the component.
Set current time.
Unplug the AC power cord from the wall outlet, and
then plug in again after about one minute.
Position the FM antenna as high and as far away
from nearby roads as possible. Connect using a
coaxial cable.
Check the antenna connection.
Install a multi-element type FM antenna if possible.
Install an antenna appropriate for the electric field
strength of your area.
Reprogram memory presets.
The problem is difficult to eliminate, but can be
lessened by grounding the AM loop antenna.
Move away from the TV or microprocessor.
Properly connect the AM loop antenna.
Change orientation of the AM loop antenna.
Install an external AM loop antenna.
The AC power cord is not connected or not
completely connected.
Loose speaker connections.
The protection circuit has been activated
because of a short circuit, etc.
Incorrect cord connections.
Input source selection is not proper.
The external component connected to the
LINE IN terminal of the main unit is not
turned on.
Current time is not set.
The internal microcomputer has been frozen
by an external electric shock (lightning,
excessive static electricity, etc.) or the power
supply voltage is too low.
Interference from the starting motor of a
nearby car.
Interference from the thermostat of a nearby
electrical appliance.
Antenna input is too weak due to obstructions
or excessive distance from the broadcasting
station.
Insufficient antenna input.
Preset memory has been erased.
Interference from sources such as lightning,
fluorescent lights, electric motors or the
thermostat of nearby electrical appliance.
A TV or microprocessor is being used
nearby.
Radio signal is weak or the antenna is not
properly connected.
GENERAL
TUNER
10/TSX-10E(6.12)b 01.6.12, 4:18 PM24
To Next Page
Loading...
Need help?
Amplifier Section
