EasyManua.ls Logo

Yanmar 3JH5E - Emergency Shutdown; Checking the Engine after Operation

Yanmar 3JH5E
160 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGINE OPERATION
58 JH Series Operation Manual
Emergency Shutdown
NOTICE
Never use the emergency stop switch for a
normal engine shutdown. Use this switch
only when stopping the engine suddenly in
an emergency.
3JH5E / 4JH5E
Figure 5
If the engine cannot be shut down by the
stop switch on the panel, stop the engine
by pushing the button (Figure 5, (1)) at the
back of the stop solenoid (Figure 5, (2)).
4JH4-TE / 4JH4-HTE1 / 4JH4-HTE
Figure 6
If the engine cannot be shut down by the
stop switch on the panel, stop the engine
by moving the stop lever (Figure 6, (2)) by
hand to the left (Figure 6, (1)). The lever is
attached to the fuel injection pump.
WARNING
Sever Hazard.
Always keep hands, body parts and
loose-fitting clothes away from moving /
rotating parts such as the flywheel or
PTO shaft.
CHECKING THE ENGINE
AFTER OPERATION
Check that the power switch is off and
that the battery switch (if equipped) is
turned to off.
Fill the fuel tank. See Filling the Fuel
Tank on page 37.
Close seawater cock(s).
If there is a risk of freezing, check that
the cooling system contains enough
coolant. See Engine Coolant
Specifications on page 43.
If there is a risk of freezing, drain the
seawater system. See Drain Seawater
Cooling System on page 94.
At temperatures below 0°C (32°F), drain
seawater system and connect the
engine heater (if equipped).
2
1
027092-00X
(2)
(1)
0004488
JH5_EN_OPM.book 58 ペー 013年8月8日 木曜日 午前9時23分

Table of Contents

Related product manuals