Maintenance and inspection
9 - 83
Tab. 9-3: Error and solutions during resetting
error
[RS-232C communication]
Error code:55550017
Error during the amplifier com-
munication
Contact the local YASKAWA
branch office.
error
[RS-232C communication]
Error code:55550018
error
[RS-232C communication]
Error code:55550019
error
[RS-232C communication]
Error code:55550020
Error occur The reset will end due to an er-
ror.
• Confirm the error message and
eliminate the error.
• Repeat the reset from the begin-
ning.
Finished! (Error occur)
Operator stop The reset is ended with the
Stop switch.
Repeat the reset from the begin-
ning.
Finished! (Operator stop)
The operator has pressed the
Stop key.
Error [Any axis don't set ABSO.]
Error code:55550088
Error in the zeroing processing Contact the local YASKAWA
branch office.
Loop error
[Exceeding the maximal move-
ment pulse.]
Error code:55550097
Error in the zeroing processing Contact the local YASKAWA
branch office.
Error message Possible error Possible solution
To Next Page
Loading...
