1.2 Order Number Confirmation
1-2
1.2 Order Number Confirmation
Check that the order number of the manipulator corresponds to the NX100. The order num-
ber is located on a label as shown below.
Fig. 1 Location of Order Number Labels
THE MANIPULATOR AND THE CONTROLLER
SHOULD HAVE SAME ORDER NUMBER.
ORDER NO.
Check that the manipulator
and the NX100 have the
same order number.
Label (Enlarged View)
(a) NX100 (Front View)
(b) Manipulator (Top View)
NX100
200V 50Hz
kVA
3PHASE220V 50/60Hz
NJ2484-1
MADE IN JAPAN
DATE
SERIAL No.
ERCR-
TYPE
POWER SUPPLY
******
ORDER NO.
NJ1529
THE MANIPULATOR AND THE CONTROLLER
SHOULD HAVE SAME ORDER NUMBER.
WARNING
Do not open the door
R
E
S
E
T
OFF
TRIPPED
ON
To Next Page
Loading...
