YASKAWA SGDB Series User Manual

Servodrives Dimensional Drawings
a
0
--.
,
N
141, lol
WIMP.
N
o)
265 (10.43)
V ''''" is j
9.2.6 SGDB-05ANIII-P to 15ANLI-P SERVOPACKS
9.2.6 SGDB-05AN
Four, cri 6 (0.24) mounting holes
110 4.33
92 (3
4CN
N
O
N
to 15ANE-P SERVOPACKS
External terminals N
(M4 screws)
N
Ground terminal (M4 screw)
Inside the cover
10 (0.39) 92 (3.62)
Four, 05
( 0.80)
Mounting
Holes
3.5 (0.14)
co
10 (0.39) —
NN
N 0 0
105±0.5 3.5 (0.14)
(4.13±0.020)
112 (4.41)
View of the Mounting Surface
a
csi
E
O
Regenerative resistor
Heat sink
1111111111 11
1111111111 1111
Fan
Approx. mass: 4 kg (8.82 Ib)
Mounting
surface
0
N
Note The angle shown in the diagram above is required for
mounting. Maintain a gap at least 10 mm (0.39 in) wide
at the top and bottom.
9 -58

YASKAWA SGDB Series Specifications

General

Series	SGDB
Category	Servo Drives
Control Method	Sine-wave PWM control
Communication Interface	MECHATROLINK-II, MECHATROLINK-III
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheating, Encoder error
Ambient Temperature	0°C to 55°C (non-freezing)
Vibration Resistance	5.9 m/s2 at 10 to 55 Hz
Shock Resistance	49 m/s2
Humidity	90% RH or less (non-condensing)