Getting Started
7
To connect a PC or mobile device:
1. Connect one end of the 3.5mm jack cable to the PC/mobile port on the phone, and connect
the other end to the headset jack on the mobile device or the AUX/MIC jack on the PC.
Setup Wizard
When the IP phone is first powered on or the phone settings are reset to factory defaults, the
setup wizard will appear on the LCD screen after startup. The IP phone will play the startup
music before the setup wizard appears.
Configure the setup wizard:
1. Configure the language for the phone user interface.
The default language is English.
2. Press the Next soft key to continue, or press the Skip soft key to skip the setup wizard and
go to the idle screen.
3. Configure time and date.
For more information, refer to Time & Date on page 21.
4. Press the Next soft key to continue.
5. Configure basic network settings for the WAN port.
For more information, refer to Basic Network Settings on page 15.
6. Press the Next soft key to continue.
7. Configure the account information.
For more information, refer to Account Registration on page 19.
8. Press the Finish soft key to complete the setup wizard.
After you complete these steps, the LCD screen prompts the following, and then the phone goes
To Next Page
Loading...
