YealinkCP860 Phones Configuring Guide
52
3. Mark the desired radio box in the Intercom Mute field.
4. Mark the desired radio box in the Intercom Tone field.
5. Mark the desired radio box in the Intercom Barge field.
6. Click Save changes to accept the change.
7. Perform auto provisioning on the phone to download above configurations. For more
information on how to perform auto provisioning, refer to Downloading Configuration Files
on page 11.
Using Intercom
To place an intercom call when the target phone is idle:
1. Press the intercom key when the phone is idle.
The called destination plays a warning tone and automatically answers the call in the
speakerphone mode by default.
2. Press or the EndCall soft key, to end the intercom call.
Multicast Paging
You can use multicast paging to quickly and easily forward out time sensitive announcements to
people within the multicast group. You can configure a multicast paging key on the phone,
which allows you to send a Real Time Transport Protocol (RTP) stream to the pre-configured
multicast address(es) without involving SIP signaling. You can configure the phone to receive an
RTP stream from pre-configured multicast listening address(es) without involving SIP signaling.
You can specify up to 10 multicast listening addresses.
To Next Page
Loading...
