YealinkCP860 Phones Configuring Guide
40
5. Perform auto provisioning on the phone to download above configurations. For more
information on how to perform auto provisioning, refer to Downloading Configuration Files
on page 11.
Logo Customization
To select a logo for the phone via CommPortal phone configurator:
1. Click on Preferences->Logo.
2. Select the desired mode from the pull-down list of Logo Mode.
- If it is set to Off, the IP phone is not allowed to display a logo.
- If it is set to System logo, the LCD screen will display the system logo.
- If it is set to Custom logo, the LCD screen will display the custom logo (you need to
upload a custom logo file to the IP phone.
3. Click Save changes to accept the change.
4. Perform auto provisioning on the phone to download above configurations. For more
information on how to perform auto provisioning, refer to Downloading Configuration Files
on page 11.
You can upload your custom logo which will be shown on the idle screen.
To upload a custom logo via CommPortal phone configurator:
1. Click on Preferences->Logo.
2. Select the Custom Logo from the pull-down list of Logo Mode.
To Next Page
Loading...
