YealinkCP860 Phones Configuring Guide
14
To trigger auto provisioning via zero touch:
1. Press the zero touch key when the phone is idle.
The LCD screen prompts “Update now? 5s”.
2. Press the OK soft key.
3. Press the Next soft key.
4. Configure the provisioning server address, authentication user name and password in the
Auto Provision screen.
An example of screenshot is shown as below:
5. Press the OK soft key.
After the above configuration is completed, the IP phone will connect to the configured
provisioning server to perform the auto provisioning process.
If the first authentication is successful, you do not need to enter authentication user name and
password again in the next auto provisioning.
For more information on auto provisioning, refer to
Yealink_SIP-T2 Series_T19(P) E2_T4
Series_CP860_W56P_IP_Phones_Auto_Provisioning_Guide
.
To Next Page
Loading...
