YealinkCP860 Phones Configuring Guide
16
2. Select IPv4, IPv6 or IPv4 & IPv6 from the Internet Port Mode(IPv4/IPv6) field.
3. Click Save changes to accept the change.
4. Perform auto provisioning on the phone to download above configurations. For more
information on how to perform auto provisioning, refer to Downloading Configuration
Files on page 11.
To configure a static IPv4 address via CommPortal phone configurator:
1. Click on Network >IP Setting.
Make sure that the IP address mode is configured as IPv4 or IPv4 & IPv6.
2. Select Static IP Address from the pull-down list of Internet Port Type for IPV4.
3. Enter the desired values in the Static IP Address, Subnet Mask, Gateway, Primary DNS
and Secondary DNS fields respectively.
4. Press the Save soft key to accept the change.
To Next Page
Loading...
