YealinkCP860 Phones Configuring Guide
18
2. Select IPv4or IPv4&IPv6 from the pull-down list of Internet Port Mode(IPv4/IPv6).
3. Mark the Enabled radio box in the Static DNS field when DHCP is selected from the
pull-down list of Internet Port Type for IPV4.
4. Enter the valid value in the Primary DNS and Secondary DNS field respectively.
5. Click the Save soft key to accept the change.
6. Perform auto provisioning on the phone to download above configurations. For more
information on how to perform auto provisioning, refer to Downloading Configuration
Files on page 11.
You can also configure a static IPv6 DNS for the IP DECT phone. Before configuring it, make sure
that the IP mode is configured as IPv6 or IPv4&IPv6.
To configure Static IPv6 DNS manually via CommPortal phone configurator:
1. Click on Network >IP Setting.
2. Select IPv6or IPv4&IPv6 from the pull-down list of Internet Port Mode(IPv4/IPv6).
3. Mark the Enabled radio box in the Static DNS field when DHCP is selected from the the
pull-down list of Internet Port Type for IPV6.
To Next Page
Loading...
