YealinkCP860 Phones Configuring Guide
56
Files on page 11.
To configure priority paging group and paging priority enable features via CommPortal
phone configurator:
1. Click on Paging Groups->Setting.
2. Mark the desired radio box in the Paging Priority Enable field.
3. Select the desired value from the pull-down list of Priority Paging Group.
4. Click Save changes to accept the change.
5. Perform auto provisioning on the phone to download above configurations. For more
information on how to perform auto provisioning, refer to Downloading Configuration
Files on page 11.
Note
Using Multicast Paging
To send RTP stream:
1. Press the multicast paging key when the phone is idle.
The phone sends RTP to a preconfigured multicast address (IP: Port). Any phone in the local
network then listens to the RTP on the preconfigured multicast address (IP: Port). For both
sending and receiving of the multicast RTP, there is no SIP signaling involved.
LED indicators illuminate solid green.
The following figure shows a multicast RTP session on the phone:
2. Press the Hold soft key to place the current multicast RTP session on hold.
3. Press the EndCall soft key to cancel the multicast RTP session.
The priorities of listening addresses are predefined: 1 with the highest priority, 10 with the lowest.
Both the multicast paging sender and receiver’s phones play a warning tone when establishing a
To Next Page
Loading...
