Yealink CTP18-STD Administrator's Guide

| Configuring Network Settings | 80
Procedure
1. Do one of the following:
• On your web user interface, go to Network > LAN Configuration > IPv4/IPv6.
• On your VCS: go to More > Settings > Network Setting > Wired Network > IPv4/IPv6.
For VP59, tap > Settings > Network Setting > Wired Network > IPv4/IPv6.
•
On your CTP20/CTP18, tap > Settings > Network Setting > Host Network > Network > Wired
Network > IPv4/IPv6.
2. Configure and save the following settings:
Parameter Description Configuration Method
Static DNS
Enable or disable DNS feature.
Default: Off.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20/CTP18
Primary DNS/Pri.DNS
Configure the primary DNS
server assigned to the system.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20/CTP18
Secondary DNS/Sec.DNS
Configure the secondary DNS
server assigned to the system.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20/CTP18
Related information
Configuring IPv4 or IPv6
DHCP Options
The DHCP information with labels carries with the corresponding network and other control information.
The information is called option. After connected to the network, the device will broadcast the DISCOVER
request which carries the DHCP options of the network information. The DHCP server will replay the
corresponding option after receiving the request.
Note:
For more information on DHCP options, refer to RFC 2131 or RFC 2132.
• Supported DHCP Option of IPv4
• DHCP Option 42, Option 2
• DHCP Option 12
Supported DHCP Option of IPv4
The following table lists the DHCP options supported by Yealink VCS in IPv4 network.

Yealink CTP18-STD Specifications

General

Brand	Yealink
Model	CTP18-STD
Category	Touch Panel
Language	English