Yealink SIP-T21 E2 Administrator's Guide

Configuring Basic Features
319
Parameters
Permitted
Values
Default
Phone User Interface:
None
dialplan.digitmap.interdigit_long_timer
Integer
from 0 to
255
10
Description:
Configures the time (in seconds) for the IP phone to wait before dialing an entered number
if it matches part of any string of the digit map.
If it is set to 0, the IP phone will not dial the entered number if it only a partial match exists.
The value of this parameter should be greater than that configured by the parameter
“dialplan.digitmap.interdigit_short_timer”.
For example:
dialplan.digitmap.string = 1xxT|xxxxx<T1>
dialplan.digitmap.interdigit_long_timer = 10
dialplan.digitmap.interdigit_short_timer = 5
When you enter 1, it matches part of two digit maps, the IP phone tries to wait 10 seconds
and then dials out 1 if no numbers entered;
When you enter 15, it also matches part of two digit maps, the IP phone tries to wait 10
seconds and then dials out 15 if no numbers entered;
When you enter 153, it also matches part of two digit maps, the IP phone tries to wait 10
seconds. But after waiting for 5 seconds, it completely matches the first digit map and then
immediately dials out 153.
Note: It works only if the value of the parameter “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.interdigit_long_timer” takes precedence over that
configured by this parameter.
Web User Interface:
None
Phone User Interface:
None
dialplan.digitmap.interdigit_short_timer
Refer to
the
following
content
3
Description:
Configures the timeout interval (in seconds) for any string of digit map.

Yealink SIP-T21 E2 Specifications

General

Brand	Yealink
Model	SIP-T21 E2
Category	IP Phone
Language	English