Yealink SIP-T21 E2

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series/CP860/CP920 IP Phones
612
Ring Type for BLF Pickup
Ring type for BLF pickup allows you to configure a different ring tone to distinguish the
incoming call on your phone from that on the monitored phone. It helps clearly notify you of
the ringing state of a monitored phone. To use this feature, you need to enable audio alert for
BLF pickup feature in advance.
Procedure
Configuration changes can be performed using the following methods.
Central
Provisioning
(Configuration
File)
<y0000000000xx>.c
fg
Specify whether to use visual alert and
audio alert for BLF pickup.
Parameters:
features.pickup.blf_visual_enable
features.pickup.blf_audio_enable
Configure ring type for BLF pickup.
Parameter:
features.blf.ring_type
Web User Interface
Specify whether to use visual alert and
audio alert for BLF pickup.
Configure ring type for BLF pickup.
Navigate to:
http://<phoneIPAddress>/servlet?p=featur
es-callpickup&q=load
Phone User Interface
Configure ring type for BLF pickup.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
features.pickup.blf_visual_enable
0 or 1
0
Description:
Enables or disables the IP phone to display a visual alert when the monitored user receives
an incoming call.
0-Disabled
1-Enabled
Note: It is not applicable to SIP-T19(P) E2/CP860/CP920 IP phones.
Web User Interface:
Features->Call Pickup->Visual Alert for BLF Pickup