Configuring Basic Features
115
Always field.
2) Enter the destination number you want to forward all incoming calls to in the
Forward To field.
3) (Optional.) Enter the always forward on code and off code respectively in the
On Code and Off Code fields.
You can also configure the always forward for all accounts. After the always
forward was configured for a specific account, do the following:
1) Press or to highlight the Always field.
2) Press the All Lines soft key.
The LCD screen prompts “Copy to All Lines?”.
3) Press the OK soft key to accept the change.
b) If you select Busy Forward, you can configure it for a specific account.
1) Press or , or the Switch soft key to select the desired value from the
Busy field.
2) Enter the destination number you want to forward all incoming calls to when
the IP phone is busy in the Forward To field.
3) (Optional.) Enter the busy forward on code and off code respectively in the
On Code and Off Code fields.
You can also configure the busy forward for all accounts. After the busy forward
was configured for a specific account, do the following:
1) Press or to highlight the Busy field.
2) Press the All Lines soft key.
The LCD screen prompts “Copy to All Lines?”.
3) Press the OK soft key to accept the change.
c) If you select No Answer Forward, you can configure it for a specific account.
1) Press or , or the Switch soft key to select the desired value from the
No Answer field.
2) Enter the destination number you want to forward all unanswered incoming
calls to in the Forward To field.
3) Press or , or the Switch soft key to select the ring time to wait before
forwarding from the After Ring Time field
The default ring time is 12 seconds.
4) (Optional.) Enter the no answer forward on code and off code respectively in
the On Code and Off Code fields.
You can also configure the no answer forward for all accounts. After the no answer
forward was configured for a specific account, do the following:
1) Press or to highlight the No Answer field.
2) Press the All Lines soft key.
The LCD screen prompts “Copy to All Lines?”.
To Next Page
Loading...
Need help?
General