Yealink SIP-T2XP - Page 291

Appendix
275
Parameter-
network.pppoe.password
Configuration File
<y0000000000xx>.cfg
Description
Configures the PPPoE password when the
Internet port type is configured as PPPoE and
the IP address mode is configured as IPv4 or
IPv4&IPv6.
Note: If you change this parameter, the IP
phone will reboot to make the change take
effect.
Format
String
Default Value
Blank
Range
String within 99 characters
Example
network.pppoe.password = yealink123
Internet Port Transmission Method
Parameter-
network.internet_port.speed_d
uplex
Configuration File
<y0000000000xx>.cfg
Description
Configures the transmission method of Internet
port.
Note: We recommend that you do not change
this parameter. If you change this parameter,
the IP phone will reboot to make the change
take effect.
Format
Integer
Default Value
0
Range
Valid values are:
0-Auto negotiate
1-Full duplex, 10Mbps
2-Full duplex, 100Mbps
3-Half duplex, 10Mbps
4-Half duplex, 100Mbps
Example
network.internet_port.speed_duplex = 0