Yealink SIP-T2XP - Page 166

Administrator’s Guide for SIP-T2xP IP Phones
154
will reboot to make the change take effect.
Format
Integer
Default Value
Blank
Range
0 to 65535
Example
network.snmp.port = 1008
Parameter-
network.snmp.trust_ip
Configuration File
<y0000000000xx>.cfg
Description
Specifies the addresses (at most three
addresses, each separated by space) from
which SNMP requests will be accepted.
Note: If you change this parameter, the phone
will reboot to make the change take effect.
Format
IP Address
Default Value
Blank
Range
Not Applicable
Example
network.snmp.trust_ip = 192.168.1.50
192.168.1.51
Parameter-
network.802_1x.mode
Configuration File
<y0000000000xx>.cfg
Description
Enables or disables the IP phone to use the
802.1X authentication.
Note: If you change this parameter, the phone
will reboot to make the change take effect.
Format
Integer
Default Value
0
Range
0-Disabled
1-EAP-MD5
2-EAP-TLS
3-PEAP-MSCHAPV2
Example
network.802_1x.mode = 1