Yealink VC Series - Page 43

Configuring Network
33
3. Press the Save soft key to accept the change.
The display device prompts ―Reboot now?‖.
4. Select OK to reboot the system immediately.
If DHCP is disabled or the system cannot obtain network settings from the DHCP server,
you need to configure them manually for the system to establish network connectivity.
Network parameters need to be configured manually on the system are described
below.
Parameter
Description
Configuration Method
Static IP
Enables or disables the system to
use manually configured network
settings.
Default: Disabled
Note: If you change this
parameter, the system will reboot
to implement the changes.
Web User Interface
IP Address
Configures the IP address
assgined to the system.
Default: Blank
Note: If you change this
parameter, the system will reboot
to implement the changes.
Remote Control
Web User Interface
Subnet Mask
Configures the subnet mask
assgined to the system.
Default: Blank
Note: If you change this
parameter, the system will reboot
to implement the changes.
Remote Control
Web User Interface
Gateway
Configures the gateway
assgined to the system.
Default: Blank
Note: If you change this
parameter, the system will reboot
to implement the changes.
Remote Control
Web User Interface
Primary DNS
Configures the primary DNS
server assgined to the system.
Remote Control
Web User Interface