Yealink VC120 - Page 147

Configuring Call Preferences
131
Parameter
Description
Configuration Method
Default: Enabled
If it is set to disabled, the system
cannot place or receive calls with the
H.323 protocol.
H.323 Name
Specifies the name that gatekeepers
and gateways use to identify this
system. You can make point-to-point
calls using
H.323 names if both system are
registered to a gatekeeper.
Default: blank
Remote Control
Web User Interface
H.323 Extension
Specifies the extension that
gatekeepers and gateways use to
identify this system.
Default: blank
Note: Users can place point-to-point
calls using the extension if both
systems are registered with a
gatekeeper.
Remote Control
Web User Interface
Gatekeeper Mode
Configures the gatekeeper mode.
 Disabled—the system does not
use a gatekeeper.
 Auto—the system automatically
discovers a gatekeeper.
 Manual—specify the IP address
and port for the gatekeeper
manually.
Default: Disabled
Remote Control
Web User Interface
Gatekeeper IP
Address
1/Gatekeeper
Server 1
Configures the IP address of the
primary gatekeeper.
Remote Control
Web User Interface
Gatekeeper Port
1/Port
Configures the port of the primary
gatekeeper.
Valid values: Integer from 0 to
65535.
Default: 1719
Remote Control
Web User Interface