TA410/810 User Manual
27/63
Dial the number directly, The dial pattern is ignored.
2) Detail Mode
Choose “No” for Simple Mode, you will see the detailed configuration page as the
following picture shows. Detailed settings for Match Incoming Calls and Handle
Matched Incoming Calls are provided in Detailed Mode.
Figure 5-2 Detailed Mode Route
Table 5-2 Description of Match Incoming Calls Settings
Choose the trunk or trunk group for the incoming calls.
Match the prefix of caller ID for incoming calls.
Define the expected DID Number if this trunk passes DID
on incoming calls. Leave this field blank to match calls
with any or no DID info. You can also use pattern
matching to match a range of numbers.
Define the extension for DID number. You can input
number and “-”in this field, and the format can be xxx or
xxx-xxx. The count of the number must be only one or
equal the count of the DID number.
To Next Page
Loading...
