Yeastar Technology TA810 - DTMF Settings

TA410/810 User Manual
36/63
incoming calls.
Dial Tone
Prompt tone of off-hook dial tone.
Ringback Tone
The tone sent to caller when ringing is on.
Busy Tone
Used for busy line prompt.
Call-Waiting Tone
Used for notification in call waiting.
Congestion Tone
Used to indicate that an invalid code has been dialed, or that all
circuits (trunks) are busy and/or the call is unroutable.
2nd Dial Tone
Used for the second stage dial tone.
DTMF Settings
DTMF signal sent from TA410/810 to the receiver can be set on this page.
Digit Length and Dial Pause Between Digit: 100.100 (ms)
Default Digit Volume: -10,-10 (dB)
Figure 8-3 DTMF Settings