TA410/810 User Manual
19/63
Figure 4-4 Service Provider Trunk Settings
Table 4-3 Description of Service Provider Trunk Settings
Choose the type of trunk, “Service Provider”.
A unique label to help you identify this trunk when
listed in outbound rules, incoming rules etc. E.g.
“yeastar”.
Service provider’s hostname or IP address.
Note: 5060 is the standard port number used by SIP
protocol. Don’t change this part if it is not required.
Trunk Group
Trunk group is a feature that allows you to define specific SIP trunks to a group. A
trunk group can be used in a route. When a call is coming or going through the route,
an available trunk would be selected in the trunk group.
Figure 4-5 Trunk Group
To Next Page
Loading...
