Status Register
The status registers operate in the same manner as in remote control via the GP-IB
interface. Using the “*SPOOL?” command dedicated for remote control using the LAN
port allows you to read the status registers, as in the case with serial polling via the GP-
IB interface.
*STB?: When AQ6370C/AQ6370D/AQ6373/AQ6373B/AQ6375/AQ6375B is the
setting of the COMMAND FORMAT key
SPOLL?: When AQ6317 is the setting of the COMMAND FORMAT key
Delimiter
The delimiter for LAN-based remote control is fixed to CR + LF.
Transmission of Talker Data
When the instrument receives talker data from an external PC, it sends the data to the
external PC's buffer. It receives the external PC's buffer data and stores the query data.
Connection
The instrument can only be connected to one controller (an external PC or other device).
If the instrument receives a connection request from a controller while already connected
to another controller, the new connection is not opened and the existing connection is
kept open.
Computer Name
The instrument’s computer name is as follows.
For the AQ6370C,
“6370C@@@@@@@@@” (where “@@@@@@@@@” is the serial number)
For the AQ6370D,
“6370D@@@@@@@@@” (where “@@@@@@@@@” is the serial number)
For the AQ6373,
“6373@@@@@@@@@” (where “@@@@@@@@@” is the serial number)
For the AQ6373B,
“AQ6373B@@@@@@@@@” (where “@@@@@@@@@” is the serial number)
For the AQ6375,
“AQ6375@@@@@@@@@” (where “@@@@@@@@@” is the serial number)
For the AQ6375B,
“AQ6375B@@@@@@@@@” (where “@@@@@@@@@” is the serial number)
The machine number is a 9-digit alphanumeric number on the back of the unit. You can
not change the computer name.
3.2 Setting Up Ethernet
To Next Page
Loading...
Need help?
General
