i
IM IS8000-62EN
This manual explains the ECU Monitor Synchronization feature (/EM1 or -EM1 option) of the
IS8000 Integrated Software (hereafter referred to as the IS8000 Software). To ensure correct use,
please read this manual thoroughly before operation. To use this option, you need to perform the
following procedure on the IS8000 Software that is installed in your personal computer (PC).
• For the /EM1 option, you need to activate the IS8001 or IS8002.
• For the -EM1 option, you need to activate the IS8001EX or IS8002EX.
* * For details on how to activate the software, see the Installation Manual, IM IS8000-04EN.
After reading this manual, keep it in a safe place. The manuals for this software are listed on the
next page. Please read all manuals.
Contact information of Yokogawa offices worldwide is provided on the following sheet.
Document No. Description
PIM 113-01Z2 List of worldwide contacts
Notes
• The contents of this manual are subject to change without prior notice as a result of continuing
improvements to the instrument’s performance and functionality. The figures given in this manual
may differ from those that actually appear on your screen.
• Every effort has been made in the preparation of this manual to ensure the accuracy of its
contents. However, should you have any questions or find any errors, please contact your
nearest YOKOGAWA dealer.
• Copying or reproducing all or any part of the contents of this manual without the permission of
YOKOGAWA is strictly prohibited.
• The license management section of this licensee application is based on one or more of the
following copyrights:
Sentinel® RMS © 2005 SafeNet, Inc. All rights reserved.
Sentinel® EMS © 2009 SafeNet, Inc. All rights reserved.
Trademarks
• Microsoft, Internet Explorer, Windows, and Windows 10 are registered trademarks or trademarks
of Microsoft Corporation in the United States and/or other countries.
• Adobe and Acrobat are either registered trademarks or trademarks of Adobe Systems
Incorporated.
• Sentinel is a registered trademark of SafeNet, Inc. !!!DELETE!!!
• RAMScope is a registered trademark of DTS INSIGHT Corporation.
• In this manual, the TM and ® symbols do not accompany their respective registered trademark
or trademark names.
• Other company and product names are trademarks or registered trademarks of their respective
holders.
Revisions
• 1st Edition: March 2021
1st Edition: March 2021 (YMI)
All Rights Reserved, Copyright © 2021 Yokogawa Test & Measurement Corporation
To Next Page
Loading...
Need help?
General
