Need help?Do you have a question about the YOKOGAWA DL950 and is the answer not in the manual?
General| Model | DL950 |
|---|---|
| Category | Measuring Instruments |
| Input Channels | Up to 16 channels |
| Vertical Resolution | 16 bits |
| Display | 10.4-inch LCD |
| Input Impedance | 1 MΩ |
| Trigger Modes | Edge, Pulse Width |
| Interface | USB, Ethernet |
| Power Supply | 100 to 240 VAC, 50/60 Hz |
| Memory Capacity | Up to 2 Gpoints |
Describes the overall system configuration for synchronizing ECU monitor and waveform measuring instruments.
Explains how RAM data and waveforms are synchronized using a sample clock and defines the saved range.
Details how to physically connect an ECU monitor to the DL950 using sync signals.
Guides users on finding and selecting the connected ECU monitor and DL950 within the IS8000 software.
Explains how to define and import measurement channels for RAM data from the ECU monitor.
Describes how to set the time base in the DAQ Setting window for proper synchronization.
Details how to set measurement conditions for both the DL950 and the ECU monitor in the IS8000.
Explains the procedure for starting, stopping, and recording waveforms and RAM data.
Provides instructions on how to open or load previously saved measurement data.
Lists the key features and capabilities of the ECU Monitor Synchronization Option.
Outlines the necessary hardware and software specifications for the PC to run the option.
Lists the YOKOGAWA measuring instruments that are compatible with this synchronization option.
Details the physical connection steps for the ECU monitor and DL950 for offline synchronization.
Explains how to configure the DL950 and ECU monitor for synchronized offline measurement.
Describes the procedures for starting and stopping the measurement process in offline mode.
Covers saving data from DL950/ECU monitor and displaying it in IS8000.
To Next Page